help > Documentation for CMTOOLS
Showing 1-1 of 1 posts
Jun 7, 2014 04:06 AM | Shady El Damaty - Georgetown University
Documentation for CMTOOLS
Hello,
Thank you for providing such a wonderful research for others to use in their research. I am a bit rusty with programming in C and would like to import data into matlab using CMTOOLS. Is there any documentation for getting started with CMTOOLS? I've tried running compile.sh along with cmtools.c.
I get this error using the gcc compiler:
Undefined symbols for architecture x86_64:
"_Analyze_load", referenced from:
_seedROI in cmtool-8ca505.o
"_discrete_cosine_transform", referenced from:
_convert in cmtool-8ca505.o
"_likelihood_ratio", referenced from:
_convert in cmtool-8ca505.o
"_mutual_information", referenced from:
_convert in cmtool-8ca505.o
"_p_combination", referenced from:
_convert in cmtool-8ca505.o
"_phi_correlation", referenced from:
_convert in cmtool-8ca505.o
"_t_score", referenced from:
_convert in cmtool-8ca505.o
ld: symbol(s) not found for architecture x86_64
clang: error: linker command failed with exit code 1 (use -v to see invocation)
How do I address this?
Thank you for providing such a wonderful research for others to use in their research. I am a bit rusty with programming in C and would like to import data into matlab using CMTOOLS. Is there any documentation for getting started with CMTOOLS? I've tried running compile.sh along with cmtools.c.
I get this error using the gcc compiler:
Undefined symbols for architecture x86_64:
"_Analyze_load", referenced from:
_seedROI in cmtool-8ca505.o
"_discrete_cosine_transform", referenced from:
_convert in cmtool-8ca505.o
"_likelihood_ratio", referenced from:
_convert in cmtool-8ca505.o
"_mutual_information", referenced from:
_convert in cmtool-8ca505.o
"_p_combination", referenced from:
_convert in cmtool-8ca505.o
"_phi_correlation", referenced from:
_convert in cmtool-8ca505.o
"_t_score", referenced from:
_convert in cmtool-8ca505.o
ld: symbol(s) not found for architecture x86_64
clang: error: linker command failed with exit code 1 (use -v to see invocation)
How do I address this?